Phone: 330.220.8600
550 Crane Dr., Valley City, OH 44280

A Better Alternative to Crane Hoist Mechanical Load Brakes

A mechanical load brake provides your crane hoist with the ability to manage/control the lowering speed of the crane hoist load. The load brake should also be able to hold the load on its own.

The basic principle of a crane hoist’s mechanical load brake is the mechanical conversion (into heat, through friction) of the kinetic energy produced by the descent of the load. Heat is dissipated from the friction surfaces to the oil in the gear case and then to the atmosphere. A crane hoist’s mechanical load brake typically requires a power source (hoist motor) to lower a load, as it is needed to counteract the working against friction.

Today’s crane hoists typically do not control the rate of acceleration of a descending load without a control brake.

A Better Alternative

The most cost effective and reliable crane hoist design for affordability in bot the short and long run is a “non-load brake” crane hoist. These crane hoists of the non-load brake variety have standard two-speed hoisting for increased positioning accuracy and safety rather than the standard single speed hoisting on traditional load brake hoists. Non-load brake, two- speed hoists are the proven industry standard in the western world. For stepless speed control and increased positioning accuracy, a variable frequency drive equipped, non-load brake hoist is the modern preferred alternative.

These crane hoists can add an extra level of safety by mounting a second holding brake on the gear case. This second crane hoist brake will provide redundancy in the event of a motor brake failure or motor coupling failure. Being externally mounted, the brake can be easily maintained and inspected. Without a load brake, the gear train runs quieter, cooler and free of contamination resulting in extended life and increased reliability.

In critical applications, a brake mounted directly on the drum is available. This brake provides redundancy to the holding brake and can also be fitted with over-speed detection. This type of brake is designed to hold a load in the event of a failure anywhere in the drive train. Naturally, this option requires a higher initial investment.

en_USEnglish