Uses of EMH Cranes in General Industry
|
Double Girder Crane
This crane features box girder construction in a high heat application over a furnace. Hoist, trolley and bridge with radio controlled Variable Frequency Drive and back-up push-button station.
|
(Click on the photo above to see an enlarged version.)
|
Gantry Crane
A Double Leg Gantry with torsion box girder construction in a midwestern steel facility. Note the use of a saddle-trolley hoist to maximize lift and minimize overall crane height.
|
(Click on the photo above to see an enlarged version.)
|
Gantry Crane
This Single Leg, Double Girder Gantry has a pass-through cantilever that allows hoist movement beyond the wall on the left. A fully enclosed cab controls all crane functions.
|
(Click on the photo above to see an enlarged version.)
|
Single Girder Crane
This installation at a manufacturer of roll forming equipment consists of 15 structural cranes with capacities from 1/2 to five tons. There are five bridge crane runways, with lengths varying from 70 to 250 feet. Nearly all of the cranes are used in workstation areas., Also used at this plant are four HB Articulating Workstation Systems.
|
(Click on the photo above to see an enlarged version.)
|
Single Girder Crane
Four single girder cranes at a Midwestern mold facility are shown here.
|
(Click on the photo above to see an enlarged version.)
|
Single Girder Crane
Monobox construction allows a 95 foot span on these 10 ton Single Girder Cranes. Spans up to 120 feet are possible.
|
(Click on the photo above to see an enlarged version.)
|
Under Running Crane
A group of one, two and three ton under running cranes provides ergonomic handling of small loads at a stone fabrication plant.
|
(Click on the photo above to see an enlarged version.)
|
Under Running Crane
Multiple under running cranes can provide a manufacturing operation with complete and efficient floor coverage.
|
(Click on the photo above to see an enlarged version.)
|